Bob Lowry on When Pool pH Crashes
Low pH in pool water chemistry doesn’t get the attention high pH does, but it can cause faster and more expensive damage. When pool pH stays low, water becomes corrosive or aggressive, which means it starts “looking” for material to dissolve to reach balance. In plaster pools, that can show up as etching that turns a smooth finish rough. In any pool, low pH can attack metal components like heater headers, pump parts, and other equipment, dissolving copper or iron into the water. Those metals can stay invisible until they reach a saturation point, then precipitate out and create staining on surfaces. That’s why monitoring pH, total alkalinity, and the saturation index is not just about comfort, it’s about protecting the shell and the equipment.
A key takeaway is that metals don’t only come from corroding equipment. Copper and iron can also arrive in fill water, since both are allowed in drinking water at low levels. Over time, topping off a pool can build metal concentration enough to cause stains, especially if low pH conditions help dissolve and mobilize metals. For pool service pros, periodic copper and iron testing is a practical risk-control step, not a luxury, and accurate results matter. A reliable test kit or photometer can prevent bad decisions based on bad data. If you dose chemicals off inaccurate readings, you can push pH lower, drive corrosion, and then end up chasing stains and customer complaints that were avoidable with better testing and a consistent routine.
Surface type changes the pH story. Plaster can contribute a small ongoing source of alkalinity and calcium hardness from the surface itself, helping buffer water balance. Vinyl liner pools and fiberglass pools do not, so once pH and alkalinity drift low, there’s less natural buffering and the water can become aggressive faster. Low pH can be especially hard on vinyl; an acid exposure can bleach or strip liner color quickly, while chlorine alone may not create the same immediate effect. The same “no buffering source” issue often appears in fiberglass spas and hot tubs, where sanitizer choices also matter. Trichlor and dichlor are acidic chlorine sources and can drive pH and alkalinity down, while aeration and turbulence in many spas tends to push pH up, so the direction depends on bather load, dosing habits, and how the spa is operated.
Correcting low pH means choosing the right tool for the job. Borax can raise pH effectively without spiking total alkalinity as much as some alternatives. Baking soda (sodium bicarbonate) is primarily for raising total alkalinity, and its pH impact is limited because even a strong bicarb solution tops out around pH 8.3; it won’t reliably lift pH when you need a significant correction. Soda ash (sodium carbonate) is much stronger and raises both pH and alkalinity, making it a better fit when both numbers are low. Aeration is another powerful option: raise alkalinity to the target range, then aerate to drive pH upward without adding more chemicals. Finally, while many people obsess over tiny pH differences for “chlorine effectiveness,” cyanuric acid changes the math; maintaining the proper free chlorine level relative to CYA is often more important than chasing 7.4 versus 7.6, while still keeping pH in a comfortable range to avoid eye and skin irritation and reduce chloramine complaints.
Comments
Post a Comment